R&S FSW Series - Page 844

Remote Commands
R&S
®
FSW
844User Manual 1173.9411.02 ─ 43
[SENSe:]POWer:ACHannel:ACPairs................................................................................844
[SENSe:]POWer:ACHannel:BWIDth:ACHannel.................................................................844
[SENSe:]POWer:ACHannel:BANDwidth:ACHannel............................................................844
[SENSe:]POWer:ACHannel:BWIDth:ALTernate<ch>..........................................................844
[SENSe:]POWer:ACHannel:BANDwidth:ALTernate<ch>.....................................................844
[SENSe:]POWer:ACHannel:BWIDth[:CHANnel<ch>]......................................................... 845
[SENSe:]POWer:ACHannel:BANDwidth[:CHANnel<ch>]....................................................845
[SENSe:]POWer:ACHannel:NAME:ACHannel...................................................................845
[SENSe:]POWer:ACHannel:NAME:ALTernate<ch>............................................................846
[SENSe:]POWer:ACHannel:NAME:CHANnel<ch>.............................................................846
[SENSe:]POWer:ACHannel:SPACing[:ACHannel]............................................................. 846
[SENSe:]POWer:ACHannel:SPACing:ALTernate<ch>........................................................ 847
[SENSe:]POWer:ACHannel:SPACing:CHANnel<ch>......................................................... 847
[SENSe:]POWer:ACHannel:TXCHannel:COUNt................................................................847
[SENSe:]POWer:ACHannel:ACPairs <ChannelPairs>
This command defines the number of pairs of adjacent and alternate channels.
Parameters:
<ChannelPairs> Range: 0 to 12
*RST: 1
Manual operation: See "Number of channels: Tx, Adj" on page 170
See "Number of Adjacent Channels (Adj Count)" on page 186
[SENSe:]POWer:ACHannel:BWIDth:ACHannel <Bandwidth>
[SENSe:]POWer:ACHannel:BANDwidth:ACHannel <Bandwidth>
This command defines the channel bandwidth of the adjacent channels.
The adjacent channels are the first channels to the left and right of the transmission
channels. If you set the channel bandwidth for these channels, the R&S FSW sets the
bandwidth of the alternate channels to the same value (not for MSR signals).
For asymmetrical MSR signals, this command defines the bandwidth of the lower adja-
cent channel. To configure the bandwidth for the upper adjacent channel, use the
[SENSe:]POWer:ACHannel:BANDwidth:UACHannel command.
Steep-edged channel filters are available for fast ACLR measurements.
Parameters:
<Bandwidth> Range: 100 Hz to 1000 MHz
*RST: 14 kHz
Default unit: Hz
Manual operation: See "Channel Bandwidth" on page 174
See "Adjacent Channel Bandwidths" on page 187
[SENSe:]POWer:ACHannel:BWIDth:ALTernate<ch> <Bandwidth>
[SENSe:]POWer:ACHannel:BANDwidth:ALTernate<ch> <Bandwidth>
This command defines the channel bandwidth of the alternate channels.
Configuring and Performing Measurements