Renesas RL78/G10

RL78/G10 CHAPTER 6 TIMER ARRAY UNIT
R01UH0384EJ0311 Rev. 3.11 105
Dec 22, 2016
(6) Measurement of high-/low-level width of input signal
Counting is started by a single edge of the signal input to the timer input pin (TI0n), and the count value is captured
at the other edge. In this way, the high-level or low-level width of the input signal can be measured.
Edge detection
Timer input
(TI0n)
Capture
xxH
00H
Start
Channel n
Capture operation
(7) Delay counter
Counting is started at the valid edge of the signal input to the timer input pin (TI0n), and an interrupt is generated
after any delay period.
Edge detection
Timer input
(TI0n)
Channel n
Compare operation
Interrupt request signal
(INTTM0n)
Start
Remark n: Channel number
n = 0, 1 (for 10-pin products); n = 0 to 3 (for 16-pin products).