Renesas RL78/G10

RL78/G10 CHAPTER 12 SERIAL ARRAY UNIT
R01UH0384EJ0311 Rev. 3.11 282
Dec 22, 2016
12.3 Registers Controlling Serial Array Unit
Serial array unit is controlled by the following registers.
• Peripheral enable register 0 (PER0)
• Serial clock select register 0 (SPS0)
• Serial mode register 0n (SMR0nH, SMR0nL)
• Serial communication operation setting register 0n (SCR0nH, SCR0nL)
• Serial data register 0n (SDR0nH, SDR0nL)
• Serial flag clear trigger register 0n (SIR0n)
• Serial status register 0n (SSR0n)
• Serial channel start register 0 (SS0)
• Serial channel stop register 0 (ST0)
• Serial channel enable status register 0 (SE0)
• Serial output enable register 0 (SOE0)
• Serial output level register 0 (SOL0)
• Serial output register 0 (SO0)
• Serial clock output register 0 (CKO0)
• Noise filter enable register 0 (NFEN0)
• Input switch control register (ISC)
• Port output mode register 0 (POM0)
• Port mode control register 0 (PMC0)
• Port mode register 0 (PM0)
• Port register 0 (P0)
Remark n: Channel number (n = 0, 1)