RL78/G10 CHAPTER 13 SERIAL INTERFACE IICA
R01UH0384EJ0311 Rev. 3.11 408
Dec 22, 2016
CHAPTER 13 SERIAL INTERFACE IICA
Caution 16-pin products have a single serial interface IICA.
13.1 Functions of Serial Interface IICA
Serial interface IICA has the following three modes.
(1) Operation stop mode
This mode is used when serial transfers are not performed. It can therefore be used to reduce power consumption.
(2) I
2
C bus mode (multimaster supported)
This mode is used for 8-bit data transfers with several devices via two lines: a serial clock (SCLA0) line and a
serial data bus (SDAA0) line.
This mode complies with the I
2
C bus format and the master device can generated “start condition”, “address”,
“transfer direction specification”, “data”, and “stop condition” data to the slave device, via the serial data bus. The
slave device automatically detects these received status and data by hardware. This function can simplify the part
of application program that controls the I
2
C bus.
Since the SCLA0 and SDAA0 pins are used for open drain outputs, serial interface IICA requires pull-up resistors
for the serial clock line and the serial data bus line.
(3) Wakeup mode
The STOP mode can be released by generating an interrupt request signal (INTIICA0) when an extension code
from the master device or a local address has been received while in STOP mode. This can be set by using the
WUP0 bit of IICA control register 01 (IICCTL01).
Figure 13-1 shows a block diagram of serial interface IICA.
To Next Page
Loading...
Need help?
General
