Sel 2414 - Page 240

A.4
SEL-2414 Transformer Monitor Instruction Manual Date Code 20130214
Firmware and Manual Versions
Instruction Manual
Section 4
➤ Updated Logical Operators.
Section 5
➤ Updated Table 5.13: Thermal Element Settings.
➤ Updated Thermal Monitor Reset Functions (THER, THE C, and THE P Commands).
➤ Added three-winding mode to thermal model.
Section 6
➤ Added settings for three-winding mode (Table 6.6: Current and Voltage Transformer Settings).
➤ Updated SEL-2414 Settings Sheets.
Appendix A
➤ Updated for firmware version R304.
Appendix D
➤ Updated Configurable Data Mapping.
Appendix E
➤ Updated Table E.15: Modbus Register Map.
Appendix H
➤ Updated Table H.1: SEL-2414 Device Word Bits.
Appendix I
➤ Updated Table I.1: Available Analog Quantities.
20101222
Section 2
➤ Added Figure 2.4: Pins for Password Jumper and SELBOOT Jumper for firmware versions R302 and higher.
➤ Added Figure 2.9: Communications Ports, Figure 2.10 Digital Inputs, and Figure 2.11 Digital Outputs.
Section 3
➤ Added ACSELERATOR QuickSet Graphical Logic Editor and ACSELERATOR QuickSet Designer.
Section 4
➤ Moved latch storage to battery-backed RTC SRAM.
Section 6
➤ Added Table 6.2: Ethernet Port Device Word Bits.
➤ Added description of Alarm Contact behavior for Access Levels and Setting Change.
Section 7
➤ Added description of ETH command.
Appendix A
➤ Updated for manual update 20101222.
Appendix D
➤ Corrected DNP object 32 default value.
➤ Added detail to RTD/TC part number and DNP default map.
Appendix H
➤ Expanded explanation of ERTDFLT and IRTDFLT Device Word Bits.
20101022
Section 1
➤ Added clarification on analog processing in logic.
Section 2
➤ Added 4ACI card option.
➤ Added 8DO Form B card option.
20100624
Section 5
➤ Added Remote Analog Quantities to Figure 5.10: Thermal Monitor Block Diagram.
➤ Added Remote Analog Quantities to TMWSEL Setting in Table 5.13: Thermal Element Settings.
Table A.3 Instruction Manual Revision History (Sheet 2 of 4)
Revision Date Summary of Revisions