The Tune window Inlet menu D-11
The Tune window Inlet menu
Use the Inlet menu to configure the Inlets tab. By default, the Tune window’s
Inlets tab is configured for the Solids probe when the Cooled Probe, AGHIS, or
DCI Probe is not selected on the Inlet menu.
These options are available on the Inlet menu:
• AGHIS (All-Glass Heated Inlet System). Selecting this option adds the
AGHIS page in the Tune window.
• Cooled Probe.
•DCI Probe.
See “The Inlets tab” on page D-38, and “The AGHIS tab parameters” on
page D-40.
The Tune window Options menu
The Options menu is used to:
• Control the display of readback windows in the Tune window.
• View the status of the current scan.
• Setup the instrument.
• Perform experiment calibration.
• Create a resolution check setup file.
• Create and edit a probe ramping method file.
• Calculate ESA and Magnet Mass values for Linked Scanning mode.
• Configure the instrument settings.
• View the status of the embedded PC.
• Specify the instrument name.
• Automatically tune the instrument.
To Next Page
Loading...
