D-26 The MassLynx Tune window
4. Enter the appropriate file names and parameters.
5. Click File > Save As, and save the resolution check setup file to the file
name specified in step 2
See “To save the current resolution check setup file to a new file name:”
on page D-25.
6. In the MassLynx window, click .
7. In the Start Sample List Run dialog box, select Auto Process Samples.
8. Click OK.
Ramping the probe temperature
Click Options > Probe Ramping to open the Probe Control dialog box, which is
used to ramp the instrument’s probe temperature during tuning or data
acquisition.
See also: “Ramping the probe temperature” on page 6-14 for full details.
The Linked Scanning Utility
Use the Linked Scanning Utility dialog box to calculate the ESA and Magnet
Mass values required to monitor specific reactions in Linked Scanning mode.
See “The Linked Scanning tab” on page D-45.
To Next Page
Loading...
