Waters Autospec Premier - Configuring the Magnet and MIKES and NMRS Options; Viewing the Status Of, and Rebooting, the Instruments Embedded PC; Selecting the Instrument Name

D-28 The MassLynx Tune window
Configuring the magnet and MIKES and NMRS options
To configure the magnet characteristics, and enable/disable the MIKES or
NMRS options (if fitted) click Options > Configuration.
Viewing the status of, and rebooting, the instrument’s embedded
PC
To view the current status of the instrument’s embedded PC
Click Options > Communications Status.
To reboot the instrument’s embedded PC
1. Click Options > Communications Status.
2. In the System Manager dialog box, click Reboot.
Alternative: Reboot the EPC manually, using the EPC’s power switch;
use this method if problems are not cleared by rebooting from the
System Manager dialog box.
Selecting the instrument name
To select the instrument name
1. Click Options > Instrument Name.
2. Specify the required name in the ID text box.
3. Click OK.
Tip: You can add the instrument name to certain printouts, allowing
identification if you are using a communal printer.
Caution: Do not change the settings in AutoSpec Configuration
Settings dialog box until after consulting Waters, see “Waters contact
information” on page i-iv.