Xerox Phaser 6180 - Page 609

Phaser 6180 Color Laser Printer Service Manual I – 3
precautions, 8-6
screws, 8-6
Feed Clutch
Tray 2
troubleshooting, 4-54
Tray 3
troubleshooting, 4-55
Feed Roller
Tray 1 (MPT)
part number, 9-13
removal, 8-39
Tray 2
operation, 2-20
part number, 9-16
removal, 8-49
Tray 3
operation, 2-45
part number, 9-33
removal, 8-104
Feed Solenoid
Tray 1
troubleshooting, 4-53
Feeder Unit
components, 2-27
connector location, 10-11
operation, 2-27
Tray 2
part number, 9-15
removal, 8-43
Tray 3
part number, 9-33
removal, 8-102
wiring diagram, 10-36
firmware update, 1-26
boot controller, A-3
controller, A-4
network card, A-5
first print output time (FPOT), 1-17
free belt nip fusing (FBNF), 2-13
Front Cover
connector location, 10-10
part number, 9-7
removal, 8-14, 8-15
troubleshooting, 3-98
wiring diagram, 10-40
Fuser
Belt, 2-29
components, 2-28
connector location, 10-10
cooling down, 2-55
Exit Roller, 2-29
Exit Sensor, 2-29
Heat Lamp, 2-29
Heat Roller, 2-28
insert Fuser error, 3-32
operation, 2-28
part number, 9-21, 9-38
removal, 8-10
replace Fuser error, 3-34
temperature control, 2-55
Temperature Sensors, 2-29
Thermostat, 2-29
warming-up, 2-55
wiring diagram, 10-46
H
Humidity Sensor
connector location, 10-13
location, 2-36
operation, 2-37
part number, 9-27
removal, 8-86
troubleshooting, 3-101
wiring diagram, 10-40
HVPS
connector location, 10-12
location, 2-36
operation, 2-38
part number, 9-19
removal, 8-61
wiring diagram, 10-42
I
Image Processor Board
connector location, 10-12
location, 2-36, 2-39
operation, 2-39
part number, 9-27
removal, 8-89
wiring diagram, 10-48
Interlock Switch
location, 2-36
operation, 2-37
troubleshooting, 4-30, 4-72
wiring diagram, 10-30
J
jam errors
Duplex jam, 3-29
Exit and Registration Roll, 3-24
jam at Tray 1 (MPT), 3-18
jam at Tray 2 (feed jam), 3-22
jam at Tray 2 (feeder 1), 3-10
jam at Tray 3, 3-13
L
Laser Diode
location, 2-31
operation, 2-32
wiring diagram, 10-38
Laser Unit
components, 2-31
connector location, 10-11