Xerox WorkCentre 7132

Fault Codes
Xerox WorkCentre 7132 User Guide 409
016-749 • The printer language received from a printer driver cannot be printed on the
machine. Use the machine’s print driver. If the problem persists, contact the
Xerox Welcome Center.
• The printer language received in an iFax cannot be printed on the machine.
Request that the sender sends the document using a printer language
supported by the machine.
016-750 Printing banner sheets is canceled. Enter the System Settings mode on the
touch screen, [Print Mode Settings] > [Other Settings], select [Banner Sheet]
and set [Start Sheet], also select [Banner Sheet Tray] and set [Tray 1].
016-751 An error occurred due to insufficient memory, when the PDF direct print function
print mode is set to PostScript. Use the machine print driver, or increase the
PostScript memory.
016-753 The entered password does not match with that of the PDF file. Set the correct
password on ContentsBridge.
016-755 An error occurred when processing a print job of a print-prohibited PDF file. Use
Adobe Reader to release the print prohibition, and print the file.
016-756 The use of the service is restricted. Contact the Key Operator.
016-757 A wrong password was entered. Enter the correct password.
016-758 The account is not authorized for copying. Contact the Key Operator.
016-759 The maximum number of copies has been reached. Contact the Key Operator.
016-760 An error occurred during PostScript processing. Take one of the following
actions.
• Set for optimized speed in the print driver.
• Increase PostScript memory.
016-761 An error occurred during image processing. Set [Image Options] > [Image
Quality] > [High Speed] on the print driver, and print again. If this does not rectify
printing, set [Detailed Settings] > [Other Settings] > [Print Page Mode] on the
print driver, and try again.
016-762 The specified print language is not supported on the machine. Specify the print
language in [Print Mode] under [Port Settings].
016-764 Unable to connect to the SMTP server. Contact the System Administrator.
016-765 Unable to send e-mail due to insufficient hard disk space on the SMTP server.
Contact the System Administrator.
016-766 An error occurred on the SMTP server. Contact the System Administrator.
016-767 Unable to send e-mail due to the wrong e-mail address. Verify the e-mail
address, and try sending the e-mail again.
016-768 Unable to connect to the SMTP server due to the incorrect e-mail address of the
machine. Check the e-mail address of the machine.
Code Description and Remedy
Downloaded From ManualsPrinter.com Manuals