Xerox WorkCentre 7132 User Guide

Fault Codes
Xerox WorkCentre 7132 User Guide 419
027-588 An SMB protocol error occurred. The user account is disabled. Ask the System
Administrator to enable the user.
027-589 An SMB protocol error occurred. The user account is locked out. Ask the
System Administrator to release the lockout.
027-590 An SMB protocol error occurred. The user valid interval has expired. Obtain a
valid user account from the System Administrator, or ask the System
Administrator to extend the account interval.
027-591 An SMB protocol error occurred. The user account is restricted. The blank
password is invalid. Set the user account password.
027-593
027-599
An SMB protocol error occurred. Perform the same operation again. Contact the
Xerox Welcome Center if the problem persists.
027-706 There was no S/MIME certificate tied to the e-mail address when sending e-
mail. Import an S/MIME certificate for the e-mail address into the machine.
027-707 The S/MIME certificate tied the e-mail address when sending e-mail has
expired. Obtain a new S/MIME certificate, and import into the machine.
027-708 The S/MIME certificate tied the e-mail address when sending e-mail is
untrusted. Import a trusted S/MIME certificate into the machine
027-709 The S/MIME certificate tied the e-mail address when sending e-mail has been
revoked. Import a new S/MIME certificate into the machine
027-710 The S/MIME certificate to receive e-mail was not present. Contact the sender,
and ask them to send e-mail with an S/MIME certificate.
027-711 The sender’s S/MIME certificate was not retrieved from the received e-mail.
Import the sender’s S/MIME certificate into the machine, or attach an S/MIME
certificate to the sender’s S/MIME signature e-mail.
027-712 The received e-mail S/MIME certificate has expired or is untrusted. Contact the
sender, and ask them to send e-mail with a valid certificate.
027-713 The received e-mail was rejected, because it had been altered, possibly the
transmission route had been falsified. Contact the sender to notify them about
the possibility of falsification, and request them to resend the e-mail.
027-714 The received e-mail was rejected, because the “From” field differs from the
S/MIME signature e-mail address. Contact the sender, tell them about the
possibility of impersonation, and ask them to resend the e-mail.
027-715 The received e-mail S/MIME certificate is not registered on the machine or is not
supported on the machine. Import the sender’s S/MIME certificate into the
machine, or if already registered, enable the certificate so that it can be used on
the machine.
027-716 The received e-mail was rejected, because the S/MIME certificate was
untrusted. Contact the sender, and ask them to send e-mail with a trusted
certificate.
Code Description and Remedy
Downloaded From ManualsPrinter.com Manuals

Xerox WorkCentre 7132 Specifications

General

Brand	Xerox
Model	WorkCentre 7132
Category	All in One Printer
Language	English