Fault Codes
Xerox WorkCentre 7132 User Guide 421
033-363 An error occurred when using the fax. Turn the power off and on. Contact the
Xerox Welcome Center if the problem persists.
033-710 The document for polling has been deleted. Store the original document again.
033-712 The processing could not continue due to insufficient system memory. Delete
unnecessary data.
033-713 An error occurred when using the fax. Turn the power off and on. Contact the
Xerox Welcome Center if the problem persists.
033-716 The mailbox specified by the remote machine does not exist. Register the
mailbox on the machine.
033-717 The mailbox password specified by the remote machine is incorrect, or the
password-receive password is incorrect. Notify the correct password to the
sender.
033-718 There are no fax documents or no documents for polling in the mailbox specified
by the remote machine. If required, store the fax document or document for
polling in the mailbox.
033-719 The fax job was canceled when the supply was turned off and on. Send the
document again.
033-721 An error occurred when using the fax. Turn the power off and on. Contact the
Xerox Welcome Center if the problem persists.
033-722 The scan job was canceled due to power supply problem, or because the
document exceeds the maximum number of pages that can be stored. Check
the power supply, or set documents that are smaller than the maximum number
of pages.
033-724 Unable to receive the image data, because the data size that can be received
per a fax transmission exceeds its upper limit. Request the sender to devide the
document into smaller segments to send, or lower the resolution. If the problem
persists, check if memory is installed correctly. If memory is installed correctly,
and not being able to identify the cause of the problem, contact the Xerox
Welcome Center.
033-725 The hard disk is full. Delete unnecessary data on the hard disk to increase the
available hard disk space.
033-726 The received document was printed single sided, because the 2-sided printing is
not available for a mixed size document. No user action is required.
033-727 The received page data size is too large to rotate automatically to shift the
document orientation on the page. The pages are printed without rotation. No
user action is required.
033-728 The Auto Print formatting of the received fax document was interrupted by a
manual print operation. No user action is required. The machine will
automatically resume the Auto Print job after manual printing is done.
033-731 The Auto Print processing for the received fax document was interrupted by a
manual print operation. No user action is required.
Code Description and Remedy
Downloaded From ManualsPrinter.com Manuals
To Next Page
Loading...
Need help?
General
