Agilent Technologies 7000B Series - Page 124

4 Triggering
124 InfiniiVision 7000B Series Oscilloscopes User’s Guide
Nth Edge Burst trigger set up consists of selecting the source, the slope of
the edge, the idle time, and the number of the edge:
1 Press the [Trigger] key in the Trigger section of the front panel, rotate
the Entry knob until Nth Edge Burst is displayed in the Trigger softkey.
2 Press the Slope softkey to specify the slope of the edge.
3 Press the Idle softkey; then, turn the Entry knob to specify the idle
time.
4 Press the Edge softkey; then, turn the Entry knob to which edge to
trigger on.
Assign
channels
Slope of
edge
Idle time
select
Trigger level
or threshold
Currently selected Clock,
Framing, or Data channel
Nth Edge Burst trigger
Nth edge
select