6 Saving, Recalling, and Printing
214 InfiniiVision 7000B Series Oscilloscopes User’s Guide
• Default
• CAN
• I2C
• LIN
• UART/RS232
• SPI (2 Wire Serial)
• SPI (3 Wire Serial)
• SPI (4 Wire Serial)
To select a serial format for the ALB data file:
1 Press [Save/Recall] > Save.
2 Press Format and select ALB.
3 Press Settings.
4 Press Format and select the format for the ALB data file.
If you connect your serial bus signals to the oscilloscope as shown in the
following table, the labels in the analysis software will be correct. If you
do not, then you will have to re- map the signals in the analysis software.
To Next Page
Loading...
