•
Indication on Axone always down: check the connector: if not OK, restore; if it is OK, dis-
connect the two terminals from the sensor and check continuity to ground of PIN 1: if there
is no continuity, restore the cable harness; if there is, replace the sensor
•
Indication on Axone always up: disconnect the terminals from the sensor and check if there
is continuity between the two PINS, with stand down: if there is continuity, replace the sensor;
if the circuit is open, it means that the brown/green cable from sensor PIN 2 to VEHICLE
connector PIN 70 is short circuit to ground: restore the cable harness
Bank angle sensor
Function
It tells the vehicle position to the control unit
Operation / operating principle
When the sensor is inverted, the circuit is closed
to ground: When the Marelli control unit detects
this ground connection, it does not enable start-up
or shuts off the engine.
Level in wiring diagram:
Start-up enabling switches
Location:
•
on the vehicle: sensor placed in the
frame front niche.
•
connector: next to the sensor (2-ways
grey connector).
Electrical characteristics:
•
Sensor in vertical position: open circuit
(resistance: 62 kOhm)
•
Sensor inverted: closed circuit (con-
tinuity)
Pin out:
1. Ground connection
2. Voltage 5V
CAUTION
BEFORE CARRYING OUT ANY TROUBLESHOOTING,
CAREFULLY READ THE GENERAL TROUBLESHOOTING
CONCEPTS FOR ELECTRICAL DEVICES AT THE BEGIN-
NING OF THE CHECK AND CONTROL SECTION IN THE
ELECTRICAL SYSTEM CHAPTER.
DIAGNOSIS INSTRUMENT: STATUSES
Fall sensor: Normal / Tip over
Electrical system RSV4 R
ELE SYS - 204
To Next Page
Loading...
Need help?
General
