User's Manual 1022 Document #: LTRT-10632
Mediant 800B Gateway & E-SBC
Figure 64-6: Viewing Message Log in Web Interface
The displayed logged messages are color-coded as follows:
• Green: Opening messages at start of message log
• Black: Notice messages
• Blue: Warning (error) messages
To stop and clear the Message Log, close the Message Log page by accessing any
another page in the Web interface.
Note:
• It's not recommended to keep a Message Log session open for a prolonged
period. This may cause the device to overload. For prolonged (and detailed)
debugging, use an external Syslog server.
• You can select the Syslog messages displayed on the page, and copy and paste
them into a text editor such as Notepad. This text file (txt) can then be sent to
AudioCodes Technical Support for diagnosis and troubleshooting.
64.3 Configuring Debug Recording
This section describes how to configure debug recording and how to collect debug
recording packets.
Note:
• Debug recording is collected only on the device's OAMP interface.
• For a detailed description of the debug recording parameters, see 'Syslog, CDR
and Debug Parameters' on page 1085.
64.3.1 Configuring the Debug Recording Server Address
The procedure below describes how to configure the address of the debug recording
server to where the device sends the captured traffic. Once you configure an address, the
device generates debug recording packets for all calls. However, you can configure the
device to generate debug recording packets for specific calls, using Logging Filter rules in
the Logging Filters table (see 'Configuring Log Filter Rules' on page 1007).
To Next Page
Loading...
