AudioCodes Mediant 800B User Manual

User's Manual 1210 Document #: LTRT-10632
Mediant 800B Gateway & E-SBC
Parameter Description
RTP DSCP for MLPP Immediate
dscp-4-mlpp-immed
[MLPPImmediateRTPDSCP]
Defines the RTP DSCP for MLPP Immediate precedence call
level.
The valid range is -1 to 63. The default is -1.
Note: If set to -1, the DiffServ value is taken from the global
parameter PremiumServiceClassMediaDiffServ or as defined in
IP Profiles per call.
RTP DSCP for MLPP Flash
dscp-4-mlpp-flsh
[MLPPFlashRTPDSCP]
Defines the RTP DSCP for MLPP Flash precedence call level.
The valid range is -1 to 63. The default is -1.
Note: If set to -1, the DiffServ value is taken from the global
parameter PremiumServiceClassMediaDiffServ or as defined in
IP Profiles per call.
RTP DSCP for MLPP Flash
Override
dscp-4-mlpp-flsh-ov
[MLPPFlashOverRTPDSCP]
Defines the RTP DSCP for MLPP Flash-Override precedence
call level.
The valid range is -1 to 63. The default is -1.
Note: If set to -1, the DiffServ value is taken from the global
parameter PremiumServiceClassMediaDiffServ or as defined in
IP Profiles per call.
RTP DSCP for MLPP Flash-
Override-Override
dscp-4-mlpp-flsh-ov-ov
[MLPPFlashOverOverRTPDSCP]
Defines the RTP DSCP for MLPP Flash-Override-Override
precedence call level.
The valid range is -1 to 63. The default is -1.
Note: If set to -1, the DiffServ value is taken from the global
parameter PremiumServiceClassMediaDiffServ or as defined in
IP Profiles per call.
72.11.5.10 Call Cut-Through Parameters
The call cut-through parameters are described in the table below.
Table 72-53: Call Cut-Through Parameters
Parameter Description
Enable Calls Cut
Through
configure voip > sip-
definition settings >
calls-cut-through
[CutThrough]
Global parameter enabling FXS endpoints to receive incoming IP calls
while the port is in off-hook state.
You can also configure the functionality per specific calls, using Tel
Profiles (TelProfile_IP2TelCutThroughCallBehavior). For a detailed
description of the parameter and for configuring the functionality in the Tel
Profiles table, see Configuring Tel Profiles on page 473.
Note:
 The parameter is applicable only to FXS interfaces.
 If the functionality is configured for a specific Tel Profile, the settings of
the global parameter is ignored for calls associated with the Tel Profile.
cut-through-anable
[DigitalCutThrough]
Global parameter enabling PSTN CAS channels/endpoints to receive
incoming IP calls even if the B-channels are in off-hook state.
You can also configure the functionality per specific calls, using Tel
Profiles (TelProfile_DigitalCutThrough). For a detailed description of the
parameter and for configuring the functionality in the Tel Profiles table, see
Configuring Tel Profiles on page 473.
Note: If the functionality is configured for a specific Tel Profile, the settings

AudioCodes Mediant 800B Specifications

General

Brand	AudioCodes
Model	Mediant 800B
Category	Gateway
Language	English