Version 7.2 909 Mediant 800B Gateway & E-SBC
User's Manual 53. SBC Configuration Wizard
53.7 Number Manipulation Page
The Number Manipulation wizard page configures caller (source) and callee (destination)
number manipulation for outbound and inbound calls.
Figure 53-7: SBC Configuration Wizard - Number Manipulation Page
To configure number manipulation:
1. Under the Outbound Calls and/or Inbound Calls groups, select the required
manipulation check box:
• Destination Number Manipulation: Manipulates the destination number.
• Source Number Manipulation: Manipulates the source number.
2. In the 'Prefix' field, configure the prefix (digits at the beginning of the number) to which
you want to apply manipulation. If configured to "*" (asterisk), manipulation is applied
to all numbers.
3. In the 'Remove' field, configure the number of digits to be removed from the beginning
of the number. If configured to "0", no digits are removed.
4. In the 'Add' field, configure a new prefix to be added to the beginning of the number. If
not configured, no prefix is added.
5. To enable routing by ARM, select the 'Use ARM for call routing' check box, and then
configure the following fields:
• 'Host': IP address or FQDN of the ARM server.
• 'Username': Username for communication with ARM.
• 'Password': Password for communication with ARM.
6. Click Next; the Remote Users (FEU) page appears (see Remote Users Page on page
910).
The example below changes the number "+15033311432" to "03311432":
Prefix: "+1503"
To Next Page
Loading...
