AudioCodes Mediant 800B - Configuring a Gateway Routing Policy Rule

Version 7.2 539 Mediant 800B Gateway & E-SBC
User's Manual 24. Routing
Parameter Description
configured in the table, the routing is done according to the
'Trunk Group ID' parameter.
 To configure the method for selecting the trunk's channel to
which the IP call is sent, see the global parameter,
ChannelSelectMode.
IP Profile
ip-profile-id
[PstnPrefix_ProfileName]
Assigns an IP Profile to the call.
To configure IP Profiles, see 'Configuring IP Profiles' on page
436.
Call Setup Rules Set ID
call-setup-rules-set-id
[PstnPrefix_CallSetupRulesSetId]
Assigns a Call Setup Rule Set ID to the routing rule. The device
performs the Call Setup rules of this Set ID if the incoming call
matches the characteristics of the routing rule. The device routes
the call to the destination according to the routing rule's
configured action, only after it has performed the Call Setup
rules.
To configure Call Setup rules, see 'Configuring Call Setup Rules'
on page 426.
24.3 Configuring a Gateway Routing Policy Rule
The Routing Policies table lets you edit the default Routing Policy rule. The Routing Policy
is used for Gateway call routing and defines the following:

LDAP server (LDAP Server Group) for LDAP-based call routing (LDAP and/or Call
Setup Rules queries). LDAP-based routing is applicable to Tel-to-IP routing
('Configuring Tel-to-IP Routing Rules' on page
525) and IP-to-Tel routing ('Configuring
IP-to-Tel Routing Rules' on page 534).

Enables Least Cost Routing (LCR), and defines default call cost (highest or lowest)
and average call duration for Tel-to-IP routing rules that are not assigned LCR Cost
Groups. The default call cost determines whether matched routing rules that are not
assigned a Cost Group are considered as a higher or lower cost route compared to
other matching routing rules that are assigned Cost Groups. If you disable LCR, the
device ignores the Cost Groups assigned to Tel-to-IP routing rules in the Tel-to-IP
Routing table. LCR is applicable only to Tel-to-IP routing.
The following procedure describes how to configure Routing Policy rules through the Web
interface. You can also configure it through ini file (GwRoutingPolicy) or CLI (configure voip
> gateway routing gw-routing-policy).
 To edit the Routing Policy rule:
1. Open the Routing Policies table (Setup menu > Signaling & Media tab > Gateway
folder > Routing > Routing Policies).