User's Manual 1220 Document #: LTRT-10632
Mediant 800B Gateway & E-SBC
Parameter Description
connected trunk sends an AIS alarm to its' Far-End.
[0] = (Default) Disable
[1] = Enable
Note:
For the parameter to take effect, a device reset is required.
The parameter is applicable only to PRI.
Enable TDM Tunneling
tdm-tunneling
[EnableTDMoverIP]
Enables TDM tunneling.
[0] Disable (default)
[1] Enable = Enables TDM tunneling. For more information,
see TDM Tunneling on page 500.
[2] Private Wire = Enables TDM tunneling for private wire
services. For more information, see Configuring Private Wire
Interworking on page 503.
Note:
For the parameter to take effect, a device reset is required.
The parameter is applicable only to PRI.
To enable the parameter per trunk, see the
EnableTDMOverIPforTrunk parameter.
[EnableTDMOverIPforTrunk] Enables TDM tunneling for a specific trunk. For a description of
the parameter, see EnableTDMoverIP.
iso8859-charset
[ISO8859CharacterSet]
Defines the ISO 8859 character set type (languages) for
representing the alphanumeric string of the calling name (caller
ID) in the forwarded message, for IP-to-Tel and Tel-to-IP calls.
[0] No Accented = Proprietary method where incoming INVITE
messages with any accented characters (e.g., á, é, í, ó, and ü),
which are represented in a 2-byte unicode character, are
translated to Latin-only, which are normal one-byte ASCII
characters (a, e, i, o, and u, respectively).
[1] Western European (Default)
[2] Central European
[3] South European
[4] North European
[5] Cyrillic
[6] Arabic
[7] Hebrew
Turkish
72.11.6.2 TDM Bus and Clock Timing Parameters
The TDM Bus parameters are described in the table below.
Table 72-59: TDM Bus and Clock Timing Parameters
Parameter Description
TDM Bus Parameters
PCM Law Select
configure voip > media tdm > pcm-law-
select
Determines the type of pulse-code modulation (PCM)
companding algorithm law in input and output TDM bus.
[1] Alaw