AudioCodes Mediant 800B - Open Solution Network (OSN) Parameters; Quality of Service Parameters

Version 7.2 1075 Mediant 800B Gateway & E-SBC
User's Manual 72. Configuration Parameters Reference
Parameter Description
StaticRouteTable_Destination, StaticRouteTable_PrefixLength,
StaticRouteTable_Gateway, StaticRouteTable_Description;
[ \StaticRouteTable ]
For a description of the parameter, see 'Configuring Static IP Routes' on
page 153.
72.2.4 Open Solution Network (OSN) Parameters
The OSN server parameters are described in the table below.
Table 72-12: OSN Parameters
Parameter Description
OSN Native VLAN ID
configure system >
interface osn >
native-vlan <id>
[OSNAccessVlan]
Defines the OSN Native VLAN ID.
The valid value is 0 to 4000. When set to 0 (default), the OSN uses the
device's OAMP VLAN ID. When set to any other value, it specifies a
VLAN ID configured in the Ethernet Devices table and which is assigned
to a Media and/or Control application in the IP Interfaces table.
Block OSN Port
configure system >
interface osn >
shutdown
[OSNBlockPort]
Enables or disables the Ethernet port of the internal switch that
interfaces with the OSN.
 [0] Enable (default)
 [1] Disable
configure network >
network-settings > osn-
internal-vlan
[OSNInternalVLAN]
Enables a single management platform when the device is deployed as
a Survivable Branch Appliance (SBA) in a Microsoft Skype for Business
environment. It allows configuration and monitoring of the Gateway/SBC
device through the SBA Management Interface.
 [0] = Disable (default)
 [1] = Enable
For more information, refer to the SBA Installation and Maintenance
Manual.
72.2.5 Quality of Service Parameters
The Quality of Service (QoS) parameters are described in the table below.
Table 72-13: QoS Parameters
Parameter Description
Layer-2 Class Of Service (CoS) Parameters (VLAN Tag Priority Field)
DiffServ Table
configure network > qos vlan-mapping
[DiffServToVlanPriority]
The table configures DiffServ-to-VLAN Priority mapping. For
each packet sent to the LAN, the VLAN Priority of the packet
is set according to the DiffServ value in the IP header of the
packet.
The format of this ini file is as follows:
[ DiffServToVlanPriority ]
FORMAT DiffServToVlanPriority_Index =