AudioCodes Mediant 800B - Coder Parameters

User's Manual 1160 Document #: LTRT-10632
Mediant 800B Gateway & E-SBC
Parameter Description
using Tel Profiles (TelProfile_ECNlpMode). For a detailed
description of the parameter and for configuring the
functionality in the Tel Profiles table, see Configuring Tel
Profiles on page
473.
Note:
 If the functionality is configured for a specific Tel Profile,
the settings of the global parameter is ignored for calls
associated with the Tel Profile.
configure voip > media voice > echo-
canceller-aggressive-NLP
[EchoCancellerAggressiveNLP]
Enables the Aggressive NLP at the first 0.5 second of the
call.
 [0] = Disable
 [1] = (Default) Enable. The echo is removed only in the
first half of a second of the incoming IP signal.
Note:
 For the parameter to take effect, a device reset is
required.
configure voip > media RTP-RTCP >
number-of-SID-coefficients
[RTPSIDCoeffNum]
Defines the number of spectral coefficients added to an
SID packet being sent according to RFC 3389.
The valid values are [0] (default), [4], [6], [8] and [10].
Answer Detector (AD) Parameters
Enable Answer Detector
[EnableAnswerDetector]
Currently, not supported.
Answer Detector Activity Delay
configure voip > media ipmedia >
answer-detector-activativity-delay
[AnswerDetectorActivityDelay]
Defines the time (in 100-msec resolution) between
activating the Answer Detector and the time that the
detector actually starts to operate.
The valid range is 0 to 1023. The default is 0.
Answer Detector Silence Time
[AnswerDetectorSilenceTime]
Currently, not supported.
Answer Detector Redirection
[AnswerDetectorRedirection]
Currently, not supported.
Answer Detector Sensitivity
configure voip > media ipmedia >
answer-detector-sensitivity
[AnswerDetectorSensitivity]
Defines the Answer Detector sensitivity.
The range is 0 (most sensitive) to 2 (least sensitive). The
default is 0.
72.10.2 Coder Parameters
The coder parameters are described in the table below.
Table 72-37: Coder Parameters
Parameter Description
Silk Tx Inband FEC
configure voip > media settings
Enables forward error correction (FEC) for the SILK coder.
 [0] Disable (default)