AudioCodes Mediant 800B User Manual

User's Manual 1192 Document #: LTRT-10632
Mediant 800B Gateway & E-SBC
Parameter Description
Number
configure voip > sip-definition
settings > use-dst-as-connected-
num
[UseDestinationAsConnectedNum
ber]
Asserted-Identity header. The device includes the SIP P-
Asserted-Identity header in 180 Ringing and 200 OK responses
for IP-to-Tel calls.
 [0] Disable (default)
 [1] Enable
Note:
 For this feature to function, you also need to enable the
device to include the P-Asserted-Identity header in 180/200
OK responses, by setting the AssertedIDMode parameter to
Add P-Asserted-Identity.
 If the received Q.931 Connect message contains a
Connected Party Number, this number is used in the P-
Asserted-Identity header in 200 OK response.
 The parameter is applicable to FXO, ISDN and CAS
interfaces.
Caller ID Transport Type
configure voip > media fax-
modem
> caller-ID-transport-type
[CallerIDTransportType]
Determines the device's behavior for Caller ID detection.
 [0] Disable = The caller ID signal is not detected - DTMF
digits remain in the voice stream.
 [1] Relay = (Currently not applicable.)
 [3] Mute = (Default) The caller ID signal is detected from the
Tel side and then erased from the voice stream.
Note: Caller ID detection is applicable only to FXO interfaces.
Reject Anonymous Calls Per Port Table
configure voip > gateway analog
reject-anonymous-calls
[RejectAnonymousCallPerPort]
This table parameter determines whether the device rejects
incoming anonymous calls per FXS port. If enabled, when a
device's FXS interface receives an anonymous call, it rejects the
call and responds with a SIP 433 (Anonymity Disallowed)
response.
The format of the ini file table parameter is as follows:
[RejectAnonymousCallPerPort]
FORMAT RejectAnonymousCallPerPort_Index =
RejectAnonymousCallPerPort_Enable,
RejectAnonymousCallPerPort_Port,
RejectAnonymousCallPerPort_Module;
[\RejectAnonymousCallPerPort]
Where,
 Enable = accept [0] (default) or reject [1] incoming
anonymous calls.
 Port = Port number.
 Module = Module number.
For example:
RejectAnonymousCallPerPort 0 = 0,1,1;
RejectAnonymousCallPerPort 1 = 1,2,1;
Note: The parameter is applicable only to FXS interfaces.
72.11.5.2 Call Waiting Parameters
The call waiting parameters are described in the table below.

AudioCodes Mediant 800B Specifications

General

Brand	AudioCodes
Model	Mediant 800B
Category	Gateway
Language	English