AudioCodes Mediant 800B - Least Cost Routing Parameters; Call Setup Rules Parameters

Version 7.2 1327 Mediant 800B Gateway & E-SBC
User's Manual 72. Configuration Parameters Reference
Parameter Description
LdapServerGroups_CacheEntryRemovalTimeout,
LdapServerGroups_SearchDnsMethod;
[ \LdapServerGroups ]
For more information, see 'Configuring LDAP Server Groups'
on page 256.
72.14.3 Least Cost Routing Parameters
The Least Cost Routing (LCR) parameters are described in the table below.
Table 72-80: LCR Parameters
Parameter Description
Cost Groups Table
configure voip > sip-
definition least-cost-routing
cost-group
[CostGroupTable]
Defines the Cost Groups for LCR, where each Cost Group is
configured with a name, fixed call connection charge, and a call rate
(charge per minute).
[ CostGroupTable ]
FORMAT CostGroupTable_Index =
CostGroupTable_CostGroupName,
CostGroupTable_DefaultConnectionCost,
CostGroupTable_DefaultMinuteCost;
[ \CostGroupTable ]
For example: CostGroupTable 2 = "Local Calls", 2, 1;
For more information, see 'Configuring Cost Groups' on page 285.
Cost Groups > Time Band
Table
configure voip > sip-
definition least-cost-routing
cost-group-time-bands
[CostGroupTimebands]
Defines time bands and associates them with Cost Groups.
[CostGroupTimebands]
FORMAT CostGroupTimebands_TimebandIndex =
CostGroupTimebands_StartTime, CostGroupTimebands_EndTime,
CostGroupTimebands_ConnectionCost,
CostGroupTimebands_MinuteCost;
[\CostGroupTimebands]
For more information, see 'Configuring Time Bands for Cost Groups'
on
page 286.
72.14.4 Call Setup Rules Parameters
The Call Setup Rules parameters are described in the table below.
Table 72-81: Call Setup Rules Parameters
Parameter Description
Call Setup Rules
configure voip > message
call-setup-rules
[CallSetupRules]
Defines Call Setup Rules that the device runs at call setup for LDAP-
based routing and other advanced routing logic requirements including
manipulation.
[ CallSetupRules ]
FORMAT CallSetupRules_Index = CallSetupRules_RulesSetID,
CallSetupRules_QueryType, CallSetupRules_QueryTarget,
CallSetupRules_AttributesToQuery, CallSetupRules_AttributesToGet,
CallSetupRules_RowRole, CallSetupRules_Condition,
CallSetupRules_ActionSubject, CallSetupRules_ActionType,
CallSetupRules_ActionValue;