User's Manual 860 Document #: LTRT-10632
Mediant 800B Gateway & E-SBC
7. Click Apply New License Key; the following message box appears:
Figure 48-4: Apply New License Key Message
8. Click Reset; the device begins to save the file to flash memory with a reset and the
following progress message box appears:
Figure 48-5: Reset in Progress for License Key
When the installation completes, the following message box appears:
Figure 48-6: Reset and Save-to-Flash Success Message
9. Click Close to close the message box; you are logged out of the Web interface and
prompted to log in again. The features and capabilities displayed on the License Key
page now reflect the newly installed License Key.
48.2.1.2 Installing a License Key File
You can install a License Key by loading a License Key file through the Web interface. The
procedure depends on whether the device is standalone (see Installing on Standalone
Devices on page 860) or operating in HA mode (see Installing on HA Devices on page
862).
48.2.1.2.1 Installing on Standalone Devices
When the device operates as a standalone device, the installation of a License Key can
also be done from a License Key file (or from a string, as described in Installing a License
Key String on page 859).
To Next Page
Loading...
