Version 7.2 1155 Mediant 800B Gateway & E-SBC
User's Manual 72. Configuration Parameters Reference
Parameter Description
[PreParsingManipulationSet
s]
FORMAT PreParsingManipulationSets_Index =
PreParsingManipulationSets_Name;
[ \PreParsingManipulationSets ]
For more information, see Configuring Pre-parsing Manipulation Rules
on page 424.
Pre-Parsing Manipulation Rules Table
Pre-Parsing Manipulation
Rules
configure voip >
message pre-parsing-
manip-rules
[PreParsingManipulationRul
es]
Defines Pre-parsing Manipulation rules.
The format of the ini file table parameter is as follows:
[ PreParsingManipulationRules ]
FORMAT PreParsingManipulationRules_Index =
PreParsingManipulationRules_PreParsingManSetName,
PreParsingManipulationRules_RuleIndex,
PreParsingManipulationRules_MessageType,
PreParsingManipulationRules_Pattern,
PreParsingManipulationRules_ReplaceWith;
[ \PreParsingManipulationRules ]
For more information, see Configuring Pre-parsing Manipulation Rules
on page 424.
72.9 Coders and Profile Parameters
The profile parameters are described in the table below.
Table 72-35: Profile Parameters
Parameter Description
Coder Groups Table
Coder Groups
configure voip > coders-
and-profiles audio-coders-
groups
[AudioCodersGroups]
[AudioCoders]
Defines the device's coders. Each group can consist of up to 10 coders.
The first Coder Group is the default coder list and the default Coder
Group.
The format of the ini file table parameter is as follows:
[ AudioCodersGroups ]
FORMAT AudioCodersGroups_Index = AudioCodersGroups_Name;
[ \AudioCodersGroups ]
[ AudioCoders ]
FORMAT AudioCoders_Index = AudioCoders_AudioCodersGroupId,
AudioCoders_AudioCodersIndex, AudioCoders_Name,
AudioCoders_pTime, AudioCoders_rate, AudioCoders_PayloadType,
AudioCoders_Sce, AudioCoders_CoderSpecific;
[ \AudioCoders ]
Note: For a list of supported coders and for configuring Coder Groups,
see 'Configuring Coder Groups' on page 427.
IP Profiles Table
IP Profiles
configure voip > coders-
and-profiles ip-profile
Defines the IP Profiles table. The format of the ini file table parameter is
as follows:
[IPProfile]
FORMAT IpProfile_Index = IpProfile_ProfileName,