Version 7.2 899 Mediant 800B Gateway & E-SBC
User's Manual 53. SBC Configuration Wizard
53 SBC Configuration Wizard
The SBC Configuration Wizard provides you with a quick-and-easy method for initial
configuration of your device. The SBC Configuration Wizard guides you through a
sequence of pages, assisting you in defining your device. Once the wizard is complete,
your device is sufficiently configured to successfully process and route calls in your
deployment.
The SBC Configuration Wizard is based on partially and fully tested interoperability setups
between the device and a wide range of vendors, including SIP trunking providers, IP
PBXs, and contact centers. Once you have selected the involved vendors and defined
basic settings in the SBC Configuration Wizard, it then generates a configuration file based
on the matching interoperability configuration template. Alternatively, instead of basing your
configuration on specific vendors, you can use the SBC Configuration Wizard to generate a
configuration file based on a generic template for commonly used setups. In such cases,
you may later need to manually fine-tune your configuration to suit your setup needs.
The SBC Configuration Wizard can automatically load the generated configuration (with a
reset) to the device, or you can simply save the generated configuration file to a folder on
your PC and then load the file to the device at a later stage.
The generated configuration is a good starting point to enable the successful establishment
of basic calls. For complete device configuration, you may need to manually configure
additional functionality. For example, you may need to configure security settings (e.g.,
firewalls and IDS) to ensure that the device is protected from malicious activity and DoS
attacks.
For AudioCodes' full interoperability list, visit AudioCodes website at
http://www.audiocodes.com/sbc-interoperability-list
.
Note:
• When the SBC Configuration Wizard applies the configuration template to the
device, all parameters configured by the SBC Configuration Wizard overwrite the
device's existing configuration of those parameter. Parameters not configured by
the SBC Configuration Wizard are restored to factory defaults, except basic device
settings such as management users (Web and CLI). Some of these basic settings
also appear in the SBC Configuration Wizard and their fields are automatically
populated with their current settings; if you do modify them in the SBC
Configuration Wizard, their new settings are used.
• On some wizard pages, the availability of certain fields depends on the selected
application.
To Next Page
Loading...
Need help?
General
