User's Manual 1074 Document #: LTRT-10632
Mediant 800B Gateway & E-SBC
Table 72-10: IP Network Interfaces and VLAN Parameters
Parameter Description
IP Interfaces Table
IP Interfaces
configure network >
interface network-if
[InterfaceTable]
The table configures IP network interfaces.
The format of the ini file table parameter is as follows:
[InterfaceTable]
FORMAT InterfaceTable_Index = InterfaceTable_ApplicationTypes,
InterfaceTable_InterfaceMode, InterfaceTable_IPAddress,
InterfaceTable_PrefixLength, InterfaceTable_Gateway,
InterfaceTable_VlanID, InterfaceTable_InterfaceName,
InterfaceTable_PrimaryDNSServerIPAddress,
InterfaceTable_SecondaryDNSServerIPAddress,
InterfaceTable_UnderlyingDevice;
[\InterfaceTable]
For more information, see 'Configuring IP Network Interfaces' on page
146.
VLAN Parameters
[EnableNTPasOAM] Defines the application type for Network Time Protocol (NTP) services.
[1] = OAMP (default)
[0] = Control
Note: For the parameter to take effect, a device reset is required.
72.2.3 Routing Parameters
The IP network routing parameters are described in the table below.
Table 72-11: IP Network Routing Parameters
Parameter Description
Send ICMP Unreachable
Messages
configure network >
network-settings > icmp-
disable-unreachable
[DisableICMPUnreachable]
Enables sending of ICMP Unreachable messages.
[0] Enable = (Default) Device sends these messages.
[1] Disable = Device does not send these messages.
Send and Receive ICMP
Redirect Messages
configure network >
network-settings > icmp-
disable-redirec
[DisableICMPRedirects]
Enables sending and receiving of ICMP Redirect messages.
[0] Enable = (Default) Device sends and accepts these messages.
[1] Disable = Device rejects these messages and also does not send
them.
Static Routes Table
Static Routes
configure network > static
[StaticRouteTable]
Defines up to 30 static IP routes for the device.
The format of the ini file table parameter is as follows:
[ StaticRouteTable ]
FORMAT StaticRouteTable_Index = StaticRouteTable_DeviceName,
To Next Page
Loading...
