AudioCodes Mediant 800B - Ini File Parameters; SNMP Parameters

User's Manual 1062 Document #: LTRT-10632
Mediant 800B Gateway & E-SBC
Parameter Description
Default Terminal Window
Height
configure system > cli-
settings > default-
window-height
[DefaultTerminalWindowHeight]
Defines the number (height) of output lines displayed in the CLI
terminal window. This applies to all new CLI sessions and is
preserved after device resets.
The valid value range is -1 (default) and 0-65535:
 A value of -1 means that the parameter is disabled and the
settings of the CLI command window-height is used.
 A value of 0 means that all the CLI output is displayed in the
window.
 A value of 1 or greater displays that many output lines in the
window and if there is more output, the “—MORE—" prompt is
displayed. For example, if you configure the parameter to 4, up
to four output lines are displayed in the window and if there is
more output, the “—MORE—" prompt is displayed (at which you
can press the spacebar to display the next four output lines).
Note: You can override this parameter for a specific CLI session
and configure a different number of output lines, by using the
window-height CLI command in the currently active CLI session.
72.1.4 ini File Parameters
The parameters relating to ini-file management are described in the table below.
Table 72-4: ini File Parameters
Parameter Description
[INIPasswordsDisplayType]
Defines how passwords are displayed in the ini file.
 [0] = (default) Disable. Passwords are obscured ("encoded"). The
passwords are displayed in the following syntax: $1$<obscured
password> (e.g., $1$S3p+fno=).

[1] = Enable. All passwords are hidden and replaced by an asterisk
(*).
72.1.5 SNMP Parameters
The SNMP parameters are described in the table below.
Table 72-5: SNMP Parameters
Parameter Description
Disable SNMP
configure system > snmp settings >
disable
[DisableSNMP]
Enables and disables SNMP.
 [0] No = (Default) SNMP is enabled.
 [1] Yes = SNMP is disabled.
configure system > snmp settings >
port
[SNMPPort]
Defines the device's local (LAN) UDP port used for SNMP
Get/Set commands.
The range is 100 to 3999. The default port is 161.
Note: For the parameter to take effect, a device reset is
required.