User's Manual 1214 Document #: LTRT-10632
Mediant 800B Gateway & E-SBC
Parameter Description
configure voip >
gateway dtmf-supp-
service supp-service-
settingsuse-facility-
in-req
[UseFacilityInRequest]
Enables the device to indicate the type of call forwarding service in the
Request-URI of the outgoing SIP INVITE message, using a proprietary
header parameter "facility=<call forward service>".
 [0] = (Default) Disable
 [1] = Enable
[BRICallForwardHandling]
Enables the device to handle BRI call forwarding.
 [0] Disable = (Defalt) BRI call forwarding is handled by a remote
server. The device interworks Facility message from the BRI
endpoint to SIP messages sent to the server. For more information,
see Remote Handling of BRI Call Forwarding on page 596.
 [1] Enable = BRI call forwarding is handled by the device. For more
information, see Local Handling of BRI Call Forwarding on page
598.
72.11.5.14 Character Conversion Parameters
The Character Conversion table parameter is described in the table below.
Table 72-57: Char Conversion Table Parameters
Char Conversion Table
Char Conversion
configure voip > gateway
dtmf-supp-service dtmf-
and-dialing > char-
conversion
[CharConversion]
Defines Unicode-to-ASCII character conversion rules. The format of the
ini file table parameter is as follows:
[CharConversion]
FORMAT CharConversion_Index = CharConversion_CharName,
CharConversion_FirstByte, CharConversion_SecondByte,
CharConversion_ConvertedOutput;
[\CharConversion]
For more information, see 'Converting Accented Characters from IP to
Tel' on page 628.
72.11.6 PSTN Parameters
This subsection describes the device's PSTN parameters.
72.11.6.1 General Parameters
The general PSTN parameters are described in the table below.
Table 72-58: General PSTN Parameters
Parameter Description
Trunk Name
config-voip > interface
<e1|t1|bri> name
[DigitalPortInfo_x]
Defines an arbitrary name for a trunk (where x denotes the trunk
number for the ini file parameter). This can be used to help you
easily identify the trunk.
The valid value is a string of up to 40 characters. The following
special characters can be used (without the quotes):
 " " (space)
To Next Page
Loading...
Need help?
General
