AudioCodes Mediant 800B - Telephone Keypad Sequence Parameters

User's Manual 1266 Document #: LTRT-10632
Mediant 800B Gateway & E-SBC
Parameter Description
Analog TTX Voltage
Level
[AnalogTTXVoltageLevel
]
Determines the metering signal/pulse voltage level (TTX).
 [0] 0V = 0 Vrms sinusoidal bursts.
 [1] 0.5V = (Default) 0.5 Vrms sinusoidal bursts.
 [2] 1V = 1 Vrms sinusoidal bursts
Note:
 For the parameter to take effect, a device reset is required.
 The parameter is applicable only to FXS interfaces.
Charge Codes Table
Charge Codes
configure voip > gateway
analog charge-code
[ChargeCode]
Defines metering tones and their time intervals that the FXS interface
generates to the Tel side or the Euro ISDN trunk sends in AOC Facility
messages to the PSTN (i.e., PBX).
The format of the ini file table parameter is as follows:
[ChargeCode]
FORMAT ChargeCode_Index = ChargeCode_EndTime1,
ChargeCode_PulseInterval1, ChargeCode_PulsesOnAnswer1,
ChargeCode_EndTime2, ChargeCode_PulseInterval2,
ChargeCode_PulsesOnAnswer2, ChargeCode_EndTime3,
ChargeCode_PulseInterval3, ChargeCode_PulsesOnAnswer3,
ChargeCode_EndTime4, ChargeCode_PulseInterval4,
ChargeCode_PulsesOnAnswer4;
[\ChargeCode]
Note:
 To associate a configured Charge Code to an outgoing Tel-to-IP call,
use the Tel-to-IP Routing table.
 To configure the Charge Codes table using the Web interface, see
Configuring Charge Codes Table on page 624.
72.11.10 Telephone Keypad Sequence Parameters
The telephony keypad sequence parameters are described in the table below.
Table 72-67: Telephone Keypad Sequence Parameters
Parameter Description
Call Pickup Key
configure voip > sip-definition
settings > call-pickup-key
[KeyCallPickup]
Defines the keying sequence for performing a call pick-up. Call
pick-up allows the FXS endpoint to answer another telephone's
incoming call by pressing this user-defined sequence of digits.
When the user dials these digits (e.g., #77), the incoming call from
another phone is forwarded to the user's phone.
The valid value is a string of up to 15 characters (0-
9, #, and *). By
default, no value is defined.
Note:
 Call pick-up is configured only for FXS endpoints pertaining to
the same Trunk Group.
 The parameter is applicable only to FXS interfaces.
Prefix for External Line
[Prefix2ExtLine] Defines a string prefix (e.g., '9' dialed for an external line) that
when dialed, the device plays a secondary dial tone (i.e., stutter