User's Manual 302 Document #: LTRT-10632
Mediant 800B Gateway & E-SBC
Parameter Description
Security
TLS Context
tls-context
[HTTPInterface_TLSContext]
Assigns a TLS Context for the connection with the HTTP Proxy service.
By default, the default TLS Context (Index 0) is assigned.
To configure TLS Contexts, see 'Configuring TLS Certificate Contexts'
on page 113.
Note: The parameter is applicable only if the connection protocol is
HTTPS (defined using the 'Protocol' parameter, above).
Verify Certificate
verify-cert
[HTTPInterface_VerifyCert]
Enables TLS certificate verification when the connection with the proxy
service is based on HTTPS.
 [0] No = (Default) No certificate verification is done.
 [1] Yes = The device verifies the authentication of the certificate
received from the HTTPS peer. The device authenticates the
certificate against the trusted root certificate store associated with
the associated TLS Context (see 'TLS Context' parameter above)
and if ok, allows communication with the HTTPS peer. If
authentication fails, the device denies communication (i.e.,
handshake fails). The device can also authenticate the certificate by
querying with an Online Certificate Status Protocol (OCSP) server
whether the certificate has been revoked. This is also configured for
the associated TLS Context.
Note: The parameter is applicable only if the connection protocol is
HTTPS (defined using the 'Protocol' parameter, above).
15.7.4 Configuring HTTP Proxy Services
The HTTP Proxy Services table lets you configure up to 10 HTTP Proxy Services.
The following procedure describes how to configure HTTP Proxy Services through the Web
interface. You can also configure it through ini file (HTTPProxyService) or CLI (configure network
> http-proxy http-proxy-serv).
 To configure an HTTP Proxy Service:
1. Open the HTTP Proxy Services table (Setup menu > IP Network tab > HTTP Proxy folder >
HTTP Proxy Services).
2. Click New; the following dialog box appears:
Figure 15-53: HTTP Proxy Services Table - Add Dialog Box
3. Configure an HTTP Proxy service according to the parameters described in the table below.
To Next Page
Loading...
Need help?
General
