AudioCodes Mediant 800B - Security Parameters; General Security Parameters

User's Manual 1094 Document #: LTRT-10632
Mediant 800B Gateway & E-SBC
Parameter Description
Source Interface Name
configure network > high-
availability > net-mon-
source-interface
[HAPingSourceIfName]
Defines the device's IP network interface from where the ping is sent.
The valid value is the name of the IP interface as configured in the
'Interface Name' field of the IP Interfaces table. By default, no I
P network
is defined.
Ping Timeout
configure network > high-
availability > net-mon-ping-
timeout
[HAPingTimeout]
Defines the timeout (in seconds) for which the ping request waits for a
reply.
The valid value is 1 to 60. The default is 1.
Ping Retries
configure network > high-
availability > net-mon-ping-
retries
[HAPingRetries]
Defines the number of ping requests that the device sends after no
response is received from the destination, before the destination is
declared unavailable. For example, if you specify 2, the destination is
declared as down after three consecutive ping requests fail to evoke a
response from the destination.
The valid value is 0 to 100. The default 2.
72.5 Security Parameters
This subsection describes the device's security parameters.
72.5.1 General Security Parameters
The general security parameters are described in the table below.
Table 72-24: General Security Parameters
Parameter Description
Firewall Table