Version 7.2 855 Mediant 800B Gateway & E-SBC
User's Manual 47. Auxiliary Files
username (userJohn)
password (s3fn+fn=)
ip-group-id (1)
status (not-resgistered)
To search a user by local-user:
(sip-def-proxy-and-reg)# user-info find <local-user, e.g.,
JohnDoe>
JohnDee: Found at index 0 in SBC user info table, not
registered
Note: To configure the User Info table, make sure that you have enabled the feature,
as described in Enabling the User Info Table on page 847.
47.7.3.3 Configuring SBC User Info Table in Loadable Text File
The SBC User Info table can be configured as a User Info file using a text-based file (*.txt).
This file can be created using any text-based program such as Notepad. This User Info file
is the same file used for the GW User Info table. Thus, this file can include both Gateway
and SBC user information.
You can load the User Info file using any of the following methods:
Web interface - see 'Loading Auxiliary Files' on page 831
ini file, using the UserInfoFileName parameter - see 'Auxiliary and Configuration File
Name Parameters' on page
1067
Automatic Update mechanism, using the UserInfoFileURL parameter - see Automatic
Update Mechanism
To add SBC users to the SBC User Info file, use the following syntax:
[ SBC ]
FORMAT LocalUser,UserName,Password,IPGroupID
where:
[ SBC ] indicates that this part of the file is the SBC User Info table
LocalUser is the user and is used as the Request-URI user part for the AOR in the
database
UserName is the user's authentication username
Password is the user's authentication password
IPGroupID is the IP Group ID to which the user belongs and is used as the Request-
URI source host part for the AOR in the database
Note:
• Make sure that there are no spaces between the values.
• To modify the SBC User Info table using a User Info file, you need to load to the
device a new User Info file containing your modifications.
Below is an example of a configured User Info file:
[ SBC ]
FORMAT LocalUser,UserName,Password,IPGroupID
To Next Page
Loading...
Need help?
General
