AudioCodes Mediant 800B - 72 Configuration Parameters Reference; Management Parameters; General Parameters

Version 7.2 1055 Mediant 800B Gateway & E-SBC
User's Manual 72. Configuration Parameters Reference
72 Configuration Parameters Reference
The device's configuration parameters, default values, and their descriptions are
documented in this section.
Note: Parameters and values enclosed in square brackets [...] represent the ini file
parameters and their enumeration values.
72.1 Management Parameters
This section describes the device's management-related parameters.
72.1.1 General Parameters
The general management parameters are described in the table below.
Table 72-1: General Management Parameters
Parameter Description
[WebLoginBlockAutoComplete] Disables autocompletion when entering the management login
username in the 'Username' field of the device's Web interface.
Disabling autocompletion may be useful for security purposes by
hiding previously entered usernames and thereby, preventing
unauthorized access to the device's management interface.
 [0] Disable = (Default) Autocompletion is enabled and the
'Username' field automatically offers previously logged in
usernames.
 [1] Enable = Autocompletion is disabled.
[EnforcePasswordComplexity] Enables the enforcement of management login-password complexity
requirements to ensure strong passwords.
 [0] Disable (default)
 [1] Enable
For more information on password complexity requirements, see the
'Password' parameter in Configuring Management User Accounts on
page 79.
[CustomerSN] Defines a serial number (S/N) for the device.
Note: The device's original S/N is automatically added at the end of
the configured S/N. For example, if the original S/N is 8906721 and
the configured S/N is "abc123", the resultant S/N is
"abc1238906721".