Version 7.2 853 Mediant 800B Gateway & E-SBC
User's Manual 47. Auxiliary Files
Loadable User Info file - see 'Configuring SBC User Info Table in Loadable Text File'
on page
855
47.7.3.1 Configuring SBC User Info Table through Web Interface
The following procedure describes how to configure the SBC User Info table through the
Web interface.
Note:
• To configure the User Info table, make sure that you have enabled the feature, as
described in Enabling the User Info Table on page 847.
• If you load any User Info file to the device, all previously configured entries are
removed from the table in the Web interface and replaced with the entries from the
loaded User Info file.
To configure the SBC User Info table through the Web interface:
1. Open the SBC User Info table (Setup menu > Signaling & Media tab > SBC folder >
User Information).
2. Click New; the following dialog box appears:
Figure 47-7: SBC User Info Table - Add Dialog Box
3. Configure a user according to the table below.
4. Click Apply.
To register a user, select the user's table entry, and then from the Action drop-down list,
choose Register. To un-register a user, select the user, and then from the Action drop-
down list, choose Un-Register.
Table 47-3: SBC User Info Table Parameter Descriptions
Parameter Description
Index
[SBCUserInfoTable_Index]
Defines an index number for the new table row.
Note: Each row must be configured with a unique index.
To Next Page
Loading...
Need help?
General
