Version 7.2 927 Mediant 800B Gateway & E-SBC
User's Manual 56. Reporting DSP Utilization through SNMP MIB
56 Reporting DSP Utilization through SNMP
MIB
You can obtain information on the percentage of DSP resources utilized by the device,
through the SNMP MIB table, acPMDSPUsage. You can also configure low and high DSP
utilization thresholds for this MIB, that if crossed, the SNMP trap event,
acPerformanceMonitoringThresholdCrossing is sent by the device. For more information
on this MIB, refer to the SNMP Reference Guide.
To Next Page
Loading...
