AudioCodes Mediant 800B - NTP and Daylight Saving Time Parameters

User's Manual 1080 Document #: LTRT-10632
Mediant 800B Gateway & E-SBC
Parameter Description
DHCP Vendor Class table
configure network > dhcp-
server vendor-class
[DhcpVendorClass]
Defines Vendor Class Identifier (VCI) names (DHCP Option 60) for the
device's DHCP server. Only if the DHCPDiscover request message,
received from the DHCP client, contains this value does the device
provide DHCP services.
The format of the ini file table parameter is as follows:
[ DhcpVendorClass ]
FORMAT DhcpVendorClass_Index =
DhcpVendorClass_DhcpServerIndex,
DhcpVendorClass_VendorClassId;
[ \DhcpVendorClass ]
For more information, see Configuring the Vendor Class Identifier on
page 232.
DHCP Option Table
DHCP Option table
configure network > dhcp-
server option
[DhcpOption]
Defines additional DHCP Options that the device's DHCP server can use
to service its DHCP clients.
The format of the ini file table parameter is as follows:
[ DhcpOption ]
FORMAT DhcpOption_Index = DhcpOption_DhcpServerIndex,
DhcpOption_Option, DhcpOption_Type, DhcpOption_Value,
DhcpOption_ExpandValue;
[ \DhcpOption ]
For more information
, see Configuring Additional DHCP Options on page
233.
DHCP Static IP Table
DHCP Static IP table
configure network > dhcp-
server static-ip <index>
[DhcpStaticIP]
Defines static "reserved" IP addresses that the device's DHCP server
allocates to specific DHCP clients defined by MAC address.
The format of the ini file table parameter is as follows:
[ DhcpStaticIP ]
FORMAT DhcpStaticIP_Index = DhcpStaticIP_DhcpServerIndex,
DhcpStaticIP_IPAddress, DhcpStaticIP_MACAddress;
[ \DhcpStaticIP ]
For more information, see Configuring Static IP Addresses for DHCP
Clients on page 235.
72.2.9 NTP and Daylight Saving Time Parameters
The Network Time Protocol (NTP) and daylight saving time parameters are described in
the table below.
Table 72-17: NTP and Daylight Saving Time Parameters
Parameter Description
NTP Parameters
CLI path: configure system > ntp >
For more information on Network Time Protocol (NTP), see 'Simple Network Time Protocol Support'
on page 129.
Primary NTP Server Address
primary-server
Defines the IP address (in dotted-decimal notation or as an FQDN) of
the NTP server. The advantage of using an FQDN is that multiple IP