AudioCodes Mediant 800B - Quality of Experience Parameters

Version 7.2 1105 Mediant 800B Gateway & E-SBC
User's Manual 72. Configuration Parameters Reference
Parameter Description
configure network > ocsp >
default-response
[OCSPDefaultResponse]

[0] Reject (default)
 [1] Allow
72.6 Quality of Experience Parameters
The Quality of Experience (QoE) parameters are described in the table below.
Table 72-31: Quality of Experience Parameters
Parameter Description
SEM Parameters
Server IP
configure voip > qoe
settings > server-ip
[QOEServerIP]
Defines the IP address of the primary Session Experience Manager
(SEM) server to where the quality experience reports are sent.
Note: For the parameter to take effect, a device reset is required.
Redundant Server IP
configure voip > qoe
settings > redundant-
server-ip
[QOESecondaryServerIp]
Defines the IP address of the secondary SEM server to where the quality
experience reports are sent. This is applicable when the SEM > EMS
server is in Geographical Redundancy HA mode.
Note: For the parameter to take effect, a device reset is required.
Interface Name
configure voip > qoe
settings > interface-name
[QOEInterfaceName]
Defines the IP network interface on which the quality experience reports
are sent.
The default is the OAMP interface.
Note: For the parameter to take effect, a device reset is required.
QoE Connection by TLS
configure voip > qoe
settings > tls-enable
[QOEEnableTLS]
Enables a TLS connection with the SEM server.
 [0] Disable (default)
 [1] Enable
Note: For the parameter to take effect, a device reset is required.
QoE TLS Context Name
configure voip > qoe
settings > tls-context-
name
[QoETLSContextName]
Selects a TLS Context (configured in the TLS Contexts table) for the TLS
connection with the SEM server.
The valid value is a string representing the name of the TLS Context as
configured in the 'Name' field of the TLS Contexts table. The default is
the default TLS Context (ID 0).
QoE Report Mode
report-mode
[QoeReportMode]
Defines at what stage of the call the device sends the QoE data of the
call to the SEM server.
 [0] Report QoE During Call (default)
 [1] Report QoE at End of Call
Note: If a QoE traffic overflow between SEM and the device occurs, the
device sends the QoE data only at the end of the call, regardless of the
settings of the parameter.
Quality of Experience Profile Table