EasyManuals Logo

AudioCodes Mediant 800B User Manual

AudioCodes Mediant 800B
1338 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #1211 background imageLoading...
Page #1211 background image
Version 7.2 1211 Mediant 800B Gateway & E-SBC
User's Manual 72. Configuration Parameters Reference
Parameter Description
of the global parameter is ignored for calls associated with the Tel Profile.
72.11.5.11 Automatic Dialing Parameters
The automatic dialing upon off-hook parameters are described in the table below.
Table 72-54: Automatic Dialing Parameters
Parameter Description
Automatic Dialing Table
Automatic Dialing Table
configure voip >
gateway analog
automatic-dialing
[TargetOfChannel]
Defines telephone numbers that are automatically dialed when a specific
FXS or FXO port is off-hooked. The format of the ini file table parameter is
as follows:
[TargetOfChannel]
FORMAT TargetOfChannel_Index = TargetOfChannel_Destination,
TargetOfChannel_Type, TargetOfChannel_Module,
TargetOfChannel_Port, TargetOfChannel_HotLineToneDuration;
[\TargetOfChannel]
For example, the below configuration defines automatic dialing of phone
number 911 when the phone connected to Port 1 of Module 1 is off-
hooked
for over 10 seconds:
TargetOfChannel 0 = 911, 1, 1, 1,10;
Note:
ï‚§ The first index of this table ini file parameter is 0.
ï‚§ TargetOfChannel_Module is the module number, where 1 denotes the
module in Slot 1.
ï‚§ TargetOfChannel_Port is the port number, where 1 denotes Port 1 on
the module.
ï‚§ This is parameter is applicable only to FXS and FXO interfaces.
ï‚§ For more information, see 'Configuring Automatic Dialing' on page 635.
72.11.5.12 Direct Inward Dialing Parameters
The Direct Inward Dialing (DID) parameters are described in the table below.
Table 72-55: DID Parameters
Parameter Description
DID Wink
configure voip > sip-
definition settings > did-
wink-enbl
[EnableDIDWink]
Global parameter enabling Direct Inward Dialing (DID) using Wink-Start
signaling, typically used for signaling between an E-911 switch and the
PSAP.
You can also configure the functionality per specific calls, using Tel
Profiles (TelProfile_EnableDIDWink). For a detailed description of the
parameter and for configuring the functionality in the
Tel Profiles table, see
'Configuring Tel Profiles' on page 473.
Note:
ï‚§ The parameter is applicable to FXS and FXO interfaces.
ï‚§
If the functionality is configured for a specific Tel Profile, the settings of

Table of Contents

Other manuals for AudioCodes Mediant 800B

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the AudioCodes Mediant 800B and is the answer not in the manual?

AudioCodes Mediant 800B Specifications

General IconGeneral
BrandAudioCodes
ModelMediant 800B
CategoryGateway
LanguageEnglish

Related product manuals