User's Manual 1084 Document #: LTRT-10632
Mediant 800B Gateway & E-SBC
Parameter Description
For information on Lifeline cabling, refer to the Installation Manual.
Delay After Reset [sec]
configure voip > sip-definition
advanced-settings > delay-
after-reset
[GWAppDelayTime]
Defines the time interval (in seconds) that the device's operation is
delayed after a reset.
The valid range is 0 to 45. The default is 7 seconds.
Note: This feature helps overcome connection problems caused by
some LAN routers or IP configuration parameters' modifications by a
DHCP server.
[EnableAutoRAITransmitBER]
Enables the device to send a remote alarm indication (RAI) when the
bit error rate (BER) is greater than 0.001.
[0] Disable (default)
[1] Enable
Ignore BRI LOS Alarm
ignore-bri-los-alarm
[IgnoreBRILOSAlarm]
Enables the device to ignore LOS alarms received from the BRI user-
side trunk and attempts to make a call (relevant for IP-to-Tel calls).
[0] Disable
[1] Enable (default)
Note: The parameter is applicable only to BRI interfaces.
72.3.2 SIP Test Call Parameters
The SIP Signaling Test Call parameters are described in the table below.
Table 72-19: SIP Test Call Parameters
Parameter Description
Test Call DTMF String
configure troubleshoot >
test-call settings > testcall-
dtmf-string
[TestCallDtmfString]
Defines the DTMF tone that is played for answered test calls (incoming
and outgoing).
The DTMF string can be up to 15 strings. The default is "3212333". If no
string is defined (empty), DTMF is not played.
Test Call ID
configure troubleshoot >
test-call settings > testcall-
id
[TestCallID]
Defines the test call prefix number (ID) of the simulated phone on the
device. Incoming calls received with this called prefix number are
identified as test calls.
This can be any string of up to 15 characters. By default, no number is
defined.
Note:
The parameter is only for testing incoming calls destined to this prefix
number.
This feature is applicable to all applications (Gateway and SBC).
Test Call Rules Table
To Next Page
Loading...
