Version 7.2 831 Mediant 800B Gateway & E-SBC
User's Manual 47. Auxiliary Files
47 Auxiliary Files
You can load the following Auxiliary files to the device.
Table 47-1: Auxiliary Files
File Description
INI Configures the device. The Web interface enables practically full device
provisioning. However, some features may only be configured by ini file or you
may wish to configure your device through ini file. For more information, see 'INI
File-Based Management' on page 105.
CAS Contains CAS Protocol definitions for CAS-terminated trunks (for various types
of CAS signaling). You can use the supplied files or construct your own files. Up
to eight different CAS files can be installed on the device. For more information,
see CAS Files on page 839.
Call Progress
Tones
Region-specific, telephone exchange-dependent file that contains the Call
Progress Tones (CPT) levels and frequencies for the device. The default CPT
file is U.S.A. For more information, see 'Call Progress Tones File' on page 834.
Prerecorded
Tones
The Prerecorded Tones (PRT) file enhances the device's capabilities of playing
a wide range of telephone exchange tones that cannot be defined in the CPT
file. For more information, see 'Prerecorded Tones File' on page 838.
Dial Plan Provides dialing plans, for example, to know when to stop collecting dialed digits
and start forwarding them or for obtaining the destination IP address for
outbound IP routing. For more information, see 'Dial Plan File' on page 839.
User Info The User Information file maps PBX extensions to IP numbers. The file can be
used to represent PBX extensions as IP phones in the global 'IP world'. For
more information, see 'User Information File' on page 847.
AMD Sensitivity Answer Machine Detector (AMD) Sensitivity file containing the AMD Sensitivity
suites. For more information, see AMD Sensitivity File on page 856.
SBC Wizard
Template Package
Contains the vendor-interoperability configuration templates for the SBC
Configuration Wizard. For more information, see SBC Configuration Wizard on
page 899.
47.1 Loading Auxiliary Files
You can load Auxiliary files to the device using one of the following methods:
Web interface - see 'Loading Auxiliary Files through Web Interface' on page 832
CLI - see Loading Auxiliary Files through CLI on page 833
TFTP - see Loading Auxiliary Files through ini File using TFTP
EMS (Software Manager) – refer to the EMS User’s Manual
To Next Page
Loading...
