User's Manual 64 Document #: LTRT-10632
Mediant 800B Gateway & E-SBC
b. Configure the referenced-row and click Apply; the referenced-table (e.g., Proxy
Sets table) closes and you are returned to the dialog box in which you selected
the Add new option (e.g., IP Groups table), where the newly added row now
appears selected.
You may want to access the referenced-table (e.g., Proxy Sets table) to simply view all its
configured rows and their settings, without selecting one. To do this, click the View button.
To return to the dialog box of the table (e.g., IP Groups table) in which you are making your
configuration, click the arrow icon on the minimized dialog box to restore it to its
previous size.
6.1.6.3 Modifying Table Rows
The following procedure describes how to modify (edit) the configuration of an existing
table row. Remember that a gray-colored dot icon displayed next to a parameter's value
(as shown in the example below), indicates that it was changed from its default value:
To edit a table row:
1. Select the row that you want to edit.
2. Click the Edit button, located on the table's toolbar; a dialog appears
displaying the current configuration settings of the row.
3. Make your changes as desired, and then click Apply; the dialog box closes and your
new settings are applied.
4. If the Save button is surrounded by a red border, you must save your
settings to flash memory, otherwise they are discarded if the device resets (without a
save to flash) or powers off.
6.1.6.4 Deleting Table Rows
The following procedure describes how to delete a row from a table.
To delete a table row:
1. Select the row that you want to delete.
2. Click the delete icon, located on the table's toolbar; a confirmation message box
appears requesting you to confirm deletion, as shown in the example below:
3. Click Yes, Delete; the row is removed from the table and the total number of
configured rows that is displayed next to the page title and page item in the Navigation
tree is updated to reflect the deletion.
To Next Page
Loading...
