User's Manual 1212 Document #: LTRT-10632
Mediant 800B Gateway & E-SBC
Parameter Description
the global parameter is ignored for calls associated with the Tel Profile.
configure voip > sip-
definition settings > time-
between-did-winks
[TimeBetweenDIDWinks]
Defines the interval (in msec) for wink signaling:
 Double-wink signaling [2]: interval between the first and second wink
 Wink and Polarity signaling [3]: interval between wink and polarity
change
The valid range is 100 to 2000. The default is 1000.
Note: See the EnableDIDWink parameter for configuring the wink
signaling type.
Delay Before DID Wink
configure voip > sip-
definition settings >
delay-b4-did-wink
[DelayBeforeDIDWink]
Defines the time interval (in msec) between the detection of the off-hook
and the generation of the DID Wink.
The valid range is 0 to 1,000. The default is 0.
Note: The parameter is applicable only to FXS interfaces.
NTT-DID-signaling-form
[NTTDIDSignallingForm]
Determines the type of DID signaling support for NTT (Japan) modem:
DTMF- or Frequency Shift Keying (FSK)-based signaling. The devices can
be connected to Japan's NTT PBX using 'Modem' DID lines. These DID
lines are used to deliver a called number to the PBX.
 [0] = (Default) FSK-based signaling
 [1] = DTMF-based signaling
Note: The parameter is applicable only to FXS interfaces.
configure voip > sip-
definition settings >
enable-did
[EnableDID]
This table parameter enables support for Japan NTT 'Modem' DID. FXS
interfaces can be connected to Japan's NTT PBX using 'Modem' DID
lines. These DID lines are used to deliver a called number to the PBX. The
DID signal can be sent alone or combined with an NTT Caller ID signal.
The format of the ini file table parameter is as follows:
[EnableDID]
FORMAT EnableDID_Index = EnableDID_IsEnable; EnableDID_Port,
EnableDID_Module;
[\EnableDID]
Where,
 IsEnable = Enables [1] or disables [0] (default) Japan NTT Modem DID
support.
 Port = Port number.
 Module = Module number.
For example:
EnableDID 0 = 1,1,2; (DID is enabled on Port 1 of Module 2)
Note: The parameter is applicable only to FXS interfaces.
configure voip >
interface fxs-fxo > wink-
time
[WinkTime]
Defines the time (in msec) elapsed between two consecutive polarity
reversals. The parameter can be used for DID signaling, for example,
E911 lines to the Public Safety Answering Point (PSAP), according to the
Bellcore GR-350-CORE standard (refer to the ini file parameter
Enable911PSAP).
The valid range is 0 to 4,294,967,295. The default is 200.
Note: For the parameter to take effect, a device reset is required.
72.11.5.13 ISDN BRI Parameters
The ISDN BRI call forwarding service parameters are described in the table below.
To Next Page
Loading...
Need help?
General
