AudioCodes Mediant 800B - Configuring an HTTP-Based EMS Service

Version 7.2 305 Mediant 800B Gateway & E-SBC
User's Manual 15. Services
Parameter Description
Security
TLS Context
tls-context
[HTTPProxyHost_TLSContext]
Assigns a TLS Context for the TLS connection with the HTTP Proxy
host.
By default, the default TLS Context (Index 0) is assigned.
To configure TLS Contexts, see 'Configuring TLS Certificate Contexts'
on page 113.
Note: The parameter is applicable only if the connection protocol is
HTTPS (defined using the 'Protocol' parameter, above).
Verify Certificate
verify-cert
[HTTPProxyHost_VerifyCert]
Enables TLS certificate verification when the connection with the host
is based on HTTPS.
 [0] No = No certificate verification is done.
 [1] Yes = (Default) The device verifies the authentication of the
certificate received from the HTTPS peer. The device
authenticates the certificate against the trusted root certificate
store associated with the associated TLS Context (see 'TLS
Context' parameter above) and if ok, allows communication with
the HTTPS peer. If authentication fails, the device denies
communication (i.e., handshake fails). The device can also
authenticate the certificate by querying with an Online Certificate
Status Protocol (OCSP) server whether the certificate has been
revoked. This is also configured for the associated TLS Context.
Note: The parameter is applicable only if the connection protocol is
HTTPS (defined using the 'Protocol' parameter, above).
15.7.5 Configuring an HTTP-based EMS Service
The EMS Services table lets you configure a single HTTP-based EMS service. For more
information on the EMS service, see 'HTTP-based Proxy Services' on page 299.
The following procedure describes how to configure an EMS Service through the Web interface.
You can also configure it through ini file (EMSService) or CLI (configure network > http-proxy
ems-serv).
 To configure an EMS Service:
1. Open the EMS Services table (Setup menu > IP Network tab > HTTP Proxy folder > EMS
Services).
2. Click New; the following dialog box appears:
Figure 15-55: EMS Services Table - Add Dialog Box