AudioCodes Mediant 800B - Viewing Gateway CDR History

User's Manual 952 Document #: LTRT-10632
Mediant 800B Gateway & E-SBC
Column Name Description

"Poor"
Note:
 The parameter is applicable only if the parameter 'Alt Routing Tel to IP
Mode' is set to 'QoS' or 'Both' (AltRoutingTel2IPMode = 2 or 3).
 The parameter is reset if two minutes elapse without a call to the
destination.
Quality Info
Displays QoS information: delay and packet loss, calculated according to
previous calls.
Note:
 The parameter is applicable only if the parameter 'Alt Routing Tel to IP
Mode' is set to 'QoS' or 'Both' (AltRoutingTel2IPMode = 2 or 3).
 The parameter is reset if two minutes elapse without a call to the
destination.
DNS Status
DNS status:
 "DNS Disable"
 "DNS Resolved"
 "DNS Unresolved"
60.6 Viewing Gateway CDR History
You can view historical (last 4,096 CDRs) Call Detail Records (CDR) of Gateway calls in a
table. CDR history information is stored on the device’s memory. When a new CDR is
generated, the device adds it to the top of the table and all existing entries are shifted one
down in the table. If the table has reached maximum capacity of entries and a new CDR is
added, the last CDR entry is removed from the table.
Note: If the device is reset, all CDRs are deleted from memory and from the table.
 To view Gateway CDR history:
 Web: Open the Gateway CDR History table (Monitor menu > Monitor tab > VoIP
Status folder > Gateway CDR History).
Figure 60-5: Gateway CDR History Table
 CLI:
• All CDR history:
# show voip calls history gw
• CDR history for a specific SIP session ID:
# show voip calls history gw <session ID>