AudioCodes Mediant 800B - NAT Parameters

User's Manual 1076 Document #: LTRT-10632
Mediant 800B Gateway & E-SBC
Parameter Description
DiffServToVlanPriority_DiffServ,
DiffServToVlanPriority_VlanPriority;
[ \DiffServToVlanPriority ]
For example:
DiffServToVlanPriority 0 = 46, 6;
DiffServToVlanPriority 1 = 40, 6;
DiffServToVlanPriority 2 = 26, 4;
DiffServToVlanPriority 3 = 10, 2;
For more information, see Configuring Quality of Service on
page 165.
Note: For the parameter to take effect, a device reset is
required.
Layer-3 Class of Service (TOS/DiffServ) Parameters
CLI path: configure network > qos application-mapping
Media Premium QoS
media-qos
[PremiumServiceClassMediaDiffServ]
Global parameter defining the DiffServ value for Premium
Media CoS content.
You can also configure this functionality per specific calls,
using IP Profiles (IpProfile_IPDiffServ) or Tel Profiles
(TelProfile_IPDiffServ). For a detailed description of the
parameter and To configure the functionality, see
'Configuring IP Profiles' on page 436 or Configuring Tel
Profiles on page 473.
Note: If the functionality is configured for a specific profile,
the settings of this global parameter is ignored for calls
associated with the profile.
Control Premium QoS
control-qos
[PremiumServiceClassControlDiffServ]
Global parameter defining the DiffServ value for Premium
Control CoS content (Call Control applications).
You can also configure the functionality per specific calls,
using IP Profiles (IpProfile_SigIPDiffServ) or Tel Profiles
(TelProfile_SigIPDiffServ). For a detailed description of the
parameter and To configure the functionality in the IP
Profiles table, see 'Configuring IP Profiles' on page 436 or
Configuring Tel Profiles on page 473.
Note: If the functionality is configured for a specific profile,
the settings of this global parameter is ignored for calls
associated with the profile.
Gold QoS
gold-qos
[GoldServiceClassDiffServ]
Defines the DiffServ value for the Gold CoS content
(Streaming applications).
The valid range is 0 to 63. The default is 26.
Bronze QoS
bronze-qos
[BronzeServiceClassDiffServ]
Defines the DiffServ value for the Bronze CoS content
(OAMP applications).
The valid range is 0 to 63. The default is 10.
72.2.6 NAT Parameters
The Network Address Translation (NAT) parameters are described in the table below.