AudioCodes Mediant 800B - LDAP Parameters

User's Manual 1324 Document #: LTRT-10632
Mediant 800B Gateway & E-SBC
Parameter Description
RADIUS Servers
configure system >
radius servers
[RadiusServers]
Defines RADIUS servers.
The format of the ini file table parameter is as follows:
[ RadiusServers ]
FORMAT RadiusServers_Index = RadiusServers_ServerGroup,
RadiusServers_IPAddress, RadiusServers_AuthenticationPort,
RadiusServers_AccountingPort, RadiusServers_SharedSecret;
[ \RadiusServers ]
For a detailed description of this table, see 'Configuring RADIUS
Servers' on page 246.
72.14.2.3 LDAP Parameters
The Lightweight Directory Access Protocol (LDAP) parameters are described in the table
below.
Table 72-79: LDAP Parameters
Parameter Description
LDAP Service
configure system > ldap settings >
ldap-service
[LDAPServiceEnable]
Enables the LDAP feature.
 [0] Disable (default)
 [1] Enable
Note: For the parameter to take effect, a device reset is
required.
LDAP Authentication Filter
configure system > ldap settings >
auth-filter
[LDAPAuthFilter]
Defines the LDAP search filter attribute for searching the
login username in the directory's subtree for LDAP-based
user authentication and authorization.
You can use the dollar ($) sign to represent the username.
For example, if the parameter is set to
"(sAMAccountName=$)" and the user logs in with the
username "SueM", the LDAP query is run for
sAMAccountName=SueM.
Use LDAP for Web > Telnet Login
configure system > ldap settings >
enable-mgmt-login
[MgmtLDAPLogin]
Enables LDAP-based management-user login authentication
and authorization.
 [0] Disable (default)
 [1] Enable
Note: For the parameter to take effect, a device reset is
required.
[LDAPDebugMode] Determines whether to enable the LDAP task debug
messages. This is used for providing debug information
regarding LDAP tasks.
The valid value range is 0 to 3. The default is 0.
LDAP Numeric Attribute
ldap-numeric-attr
[LDAPNumericAttributes]
Defines up to five LDAP Attributes (separated by commas)
for which the device employs LDAP query searches in the
AD for numbers that may have characters between the digits.
For more information, see 'Enabling LDAP Searches for
Numbers with Characters' on page 275.