AudioCodes Mediant 800B - DNS Parameters

User's Manual 1078 Document #: LTRT-10632
Mediant 800B Gateway & E-SBC
Parameter Description
The valid range is 0 to 2,592,000. The default is 30.
Note: For the parameter to take effect, a device reset is required.
SIP NAT Detection
configure voip > sip-
definition advanced-settings
> sip-nat-detect
[SIPNatDetection]
Enables the device to detect whether the incoming INVITE message is
sent from an endpoint located behind NAT.
 [0] Disable = Disables the device's NAT Detection mechanism.
Incoming SIP messages are processed as received from endpoints
that are not located behind NAT and sent according to the SIP
standard.
 [1] Enable (default) = Enables the device's NAT Detection
mechanism.
72.2.7 DNS Parameters
The Domain name System (DNS) parameters are described in the table below.
Table 72-15: DNS Parameters
Parameter Description
Internal DNS Table
Internal DNS Table
configure network > dns
dns-to-ip
[DNS2IP]
The table defines the internal DNS table for resolving host names into IP
addresses.
The format of the ini file table parameter is:
[Dns2Ip]
FORMAT Dns2Ip_Index = Dns2Ip_DomainName,
Dns2Ip_FirstIpAddress, Dns2Ip_SecondIpAddress,
Dns2Ip_ThirdIpAddress;
[\Dns2Ip]
For example:
Dns2Ip 0 = DnsName, 1.1.1.1, 2.2.2.2, 3.3.3.3, ;
For more information, see 'Configuring the Internal DNS Table' on page
170.
Internal SRV Table
Internal SRV Table
configure network > dns
srv2Ip
[SRV2IP]
The table defines the internal SRV table for resolving host names into
DNS A-Records. Three different A-Records can be assigned to a host
name. Each A-Record contains the host name, priority, weight, and port.
The format of the ini file table parameter is:
[SRV2IP]
FORMAT SRV2IP_Index = SRV2IP_InternalDomain,
SRV2IP_TransportType, SRV2IP_Dns1, SRV2IP_Priority1,
SRV2IP_Weight1, SRV2IP_Port1, SRV2IP_Dns2, SRV2IP_Priority2,
SRV2IP_Weight2, SRV2IP_Port2, SRV2IP_Dns3, SRV2IP_Priority3,
SRV2IP_Weight3, SRV2IP_Port3;
[\SRV2IP]
For example:
SRV2IP 0 =
SrvDomain,0,Dnsname1,1,1,500,Dnsname2,2,2,501,$$,0,0,0;
For more information, see 'Configuring the Internal SRV Table' on page
171.