User's Manual 1196 Document #: LTRT-10632
Mediant 800B Gateway & E-SBC
Parameter Description
Module 1 to an IP address upon On Busy:
FwdInfo 1 = 1,2003@10.5.1.1,30,1,2;
For more information, see Configuring Call Forward on page 638.
Note: The parameter is applicable only to analog interfaces.
Call Forward Reminder Ring Parameters
Note:
 These parameters are applicable only to FXS interfaces.
 For a description of this feature, see Call Forward Reminder Ring on page 593.
Enable NRT Subscription
configure voip > gateway
dtmf-supp-service supp-
service-settings > nrt-
subscription
[EnableNRTSubscription]
Enables endpoint subscription for Ring reminder event notification
feature.
 [0] Disable (default)
 [1] Enable
AS Subscribe IPGroupID
configure voip > gateway
dtmf-supp-service supp-
service-settings > as-
subs-ipgroupid
[ASSubscribeIPGroupID]
Defines the IP Group ID that contains the Application server for
Subscription.
The valid value range is 1 to 8. The default is -1 (i.e., not configured).
NRT Subscribe Retry
Time
configure voip > gateway
dtmf-supp-service supp-
service-settings > nrt-sub-
retry-time
[NRTSubscribeRetryTime]
Defines the Retry period (in seconds) for Dialog subscription if a previous
request failed.
The valid value range is 10 to 7200. The default is 120.
Call Forward Ring Tone
ID
configure voip > gateway
dtmf-supp-service supp-
service-settings > cfe-
ring-tone-id
[CallForwardRingToneID]
Defines the ringing tone type played when call forward notification is
accepted.
The valid value range is 1 to 5. The default is 1.
72.11.5.4 Message Waiting Indication Parameters
The message waiting indication (MWI) parameters are described in the table below.
Table 72-47: MWI Parameters
Parameter Description
Enable MWI
configure voip > gateway dtmf-
supp-service supp-service-
settings > enable-mwi
[EnableMWI]
Enables Message Waiting Indication (MWI).
 [0] Disable (default)
 [1] Enable
Note:
 The parameter is applicable only to FXS interfaces.
To Next Page
Loading...
Need help?
General
